AODE/4R70W/4R75 Instructions
4R70W / AODE
IMPORTANT!
PLEASE READ BEFORE INSTALLATION ON
ALL TRANSMISSIONS!!
Transmission cooler and cooler lines must be
COMPLETELY flushed prior to installation! Failure to do this can damage
transmission and VOID warranty!
Use *Kooler Kleen* - available at most auto part stores!
Fluid Instructions:
Add ½ qrt to converter. Before starting vehicle, add 8
quarts of fluid to transmission and let stand for a few minutes allowing
fluid to drain into transmission. Add 3-4 quarts more, than start engine and run
through all gears with foot on the brake. Fill to level on stick.
**NOTE** Check / research for total amount of fluid
your transmission requires to be FULL. Some transmissions drain
down slower than others, so be sure your transmission if full before driving
vehicle. If it is not full, damage will occur. **Add another quart or two after
road test**
-REMEMBER–NOT FOLLOWING ALL MANUFACTURER’S
SPECIFICATIONS, AND INSTRUCTIONS CAN/WILL CAUSE SERVERE TRANSMISSION DAMAGE AND
VOID WARRANTY!
AOD/AODE/ 4R70W –
LINKAGE
The
linkage for your shift lever may not be in the exact position you have removed
from vehicle. If this is the case it is a relatively easy swap. Simply remove
transmission pan. You will see a pin going through linkage shaft. Remove pin
with a pair of pliers (needle nose or angled cutting type). Remove large nut
from end of shaft and slide out. **Be sure to take note of position of lever
and INSTALL in same position that it was in old transmission.
This
is necessary to swap over sometimes due to the many different levers and
position of levers.
